Idiomas disponibles
Idiomas disponibles
2
installing optional u
Tools Required: 8mm x 10mm Open End Wrench, Slotted
Screwdriver, 3mm Hex Wrench.
1. Close choke and remove air filter cover.
2. Disconnect two (2) ignition stop leads (A, B).
3. Loosen nut (C) and remove throttle linkage from carburetor
bracket.
4. Remove inner throttle cable from carburetor swivel (D).
5. Loosen the two (2) drive shaft clamp bolts (E) at engine drive shaft
clamp.
6. Pull drive shaft assembly from clutch case.
7. Loosen two (2) rear handle screws (F) and pull rear handle (G)
from the drive shaft assembly.
8. Loosen four (4) screws (H) and remove front handle.
9. Insert square nut (J) in lower handle bracket (K) and place bracket
on drive shaft 400mm (15 3/4 in.) from engine end of drive shaft.
10. Secure with lower handle bracket clamp (L) and three (3) 5 x 30
mm bolts.
11. Position harness hook 220mm (8-5/8 in.) from engine end of drive
shaft assembly. Install 5 x 12 mm bolt, but DO NOT tighten at this
time.
12. Carefully fit drive shaft assembly to engine making sure inner
drive shaft engages into clutch socket.
13. Tighten two (2) drive shaft clamp bolts (E) securely.
14. Install upper U-Handle and bracket on lower bracket and secure
with one (1) 8 mm x 55 mm bolt (N) and large circular washer.
INSTALLATION INSTRUCTIONS U-HANDLE KIT
-
handle kit
B
G
H
J
K
L
400 mm
(15-3/4 in.)
220 mm
K
L
(8-5/8 in.)
N
D
E
F
ENGINE
END
