PRASTEL FSLIMRFRX Manual Del Usuario página 7

FSLIMRFRX
6. Simultaneously press keys INC and DEC to exit from programming mode.
Reading the history of events (F9)
1. Simultaneously press keys INC (blue) and DEC (red).
2. Press key FUN (yellow) to access the function selection menu.
3. Select function F9 by pressing keys INC and DEC.
4. Confirm selection by pressing the VAL (green) key; the last event registered is shown. The display shows the location of the barrier that
generated the event and the LEDs show the type of event (alarm, battery, tamper, missing supervision). If the list is empty the display
shows 000.
5. Scroll the list of events via keys INC and DEC. The last 10 events are shown.
6. Confirm by pressing key VAL; the display returns to function selection
7. Simultaneously press keys INC and DEC to exit from programming mode.
Deleting the history of events (F10)
1. Simultaneously press keys INC (blue) and DEC (red).
2. Press the FUN (yellow) key to access the function selection menu.
3. Select function F10 by pressing keys INC and DEC.
4. Confirm by pressing the VAL (green) key. The word "Can" appears on the display.
5. Confirm again by pressing the VAL key. The FSLIMRFRX fully deletes the historic area only.
6. Simultaneously press keys INC and DEC to exit from programming mode.
Entering the password (F11)
1. Simultaneously press keys INC (blue) and DEC (red).
2. Press the FUN (yellow) key to access the function selection menu.
3. Select function F11 by pressing keys INC and DEC
4. Confirm by pressing the VAL (green) key. The word "Pas" appears on the display. Digit a sequence of six keys within 10 seconds.
Each time a key is pressed, the word "Pas" flashes.
5. Upon the full sequence of six keys having been completed, the display returns to function selection
6. Simultaneously press keys INC and DEC to exit from programming mode.
Failure to complete a password sequence within 10 seconds aborts password entry. This also avoids entry of incorrect passwords in case of
any doubts as to the sequence to be entered or erroneous pressing of any key.
The password is stored in EEPROM and is requested whenever INC+DEC are pressed to access programming mode starting from the
stand-by status (display off). In this case:
1. The word "Pas" appears on the display. Digit the sequence of six keys corresponding to the password. Each time a key is pressed, the
word "Pas" flashes.
2. Upon the 6-key sequence being completed, programming mode is accessed. If sequence is erroneous, the display goes off.
Upon programming mode being accessed, any resident password may be deleted or replaced with a new one.
Note: To remove a password which has been forgotten, contact system supplier.
Deleting a resident password
1. Simultaneously press keys INC (blue) and DEC (red): the password is requested.
2. Digit in the password.
3. Press the FUN (yellow) key to access the function selection menu.
4. Select the password entry function F11 by pressing keys INC and DEC and confirm by pressing key VAL (green).
5. Allow time-out (10 seconds) to elapse; password is deleted and will not be requested upon any subsequent accessing of programming
mode.
ENGLISH
ISFSLIMRFRX_12_07.doc
7