Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WIRING COLOR CODES
NOTE: The wire colors on the LOC2SL may differ
from the wiring colors found on the car stereo / in
vehicle. Always refer to the stereo owner's manual for
wiring details/functions for your particular car stereo.
The wire color codes used on the LOC2SL conform
to the standards set by the E.I.A. (Electronics Industry
Association).
White = Left front positive input (LF+)
White/black = Left front negative input (LF-)
Gray = Right front positive input (RF+)
Gray/black = Right front negative input (RF-)
Yellow = +12 volt power input
(constant battery power)
Black = Chassis ground (vehicle metal)
Blue/white = +12V remote output (amp turn-on)
REMOTE SUB/VOLUME CONTROL
The LOC2SL includes on optional remote-mount
volume control to attenuate/control the new AMP/SUB
system level. Choose a location accessible to the driver,
passenger or both. See Figure 1 on page 6 for
suggested locations.
TIP: Check for obstructions at the chosen location
before mounting/routing the volume control.
Recommended: Use the included adhesive strip for
non-permanent mounting. Optional: For permanent
mounting, use (2) small ¼'' screws (not included).
5
Tabla de contenido
