ASROCK B360M-ITX/ac Manual De Instrucciones página 27

Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 17)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis must sup-
port HDA to function correctly. Please follow the instructions in our manual and chassis
manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by the
steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to connect
them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel and
adjust "Recording Volume".
Chassis Speaker Header
(4-pin SPEAKER1)
(see p.1, No. 16)
Chassis Fan / Waterpump
Fan Connector
(4-pin CHA_FAN1/WP)
(see p.1, No. 2)
Chassis Fan Connector
(4-pin CHA_FAN2)
(see p.1, No. 13)
GND
PRESENCE#
MIC_RET
OUT_RET
1
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
SPEAKER
DUMMY
DUMMY
+5V
1
GND
FAN_VOLTAGE
CHA_FAN_SPEED
FAN_SPEED_CONTROL
1 2 3 4
GND
1
FAN_VOLTAGE
2
CHA_FAN_SPEED
3
4
FAN_SPEED_CONTROL
This header is for
connecting audio devices
to the front audio panel.
Please connect the chassis
speaker to this header.
Please connect fan cables
to the fan connectors and
match the black wire to
the ground pin.
Please connect fan cables
to the fan connectors and
match the black wire to
the ground pin.
B360M-ITX/ac
23