Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Electrical safety
Your charger is double insulated; therefore no
earth wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Symbols on the charging base
Your charging base is double insulated; therefore
no earth wire is required.
Safety isolating transformer. The mains supply is
electrically separated from the transformer output.
The charging base is intended for indoor use only.
Features
1. Dust collector
2. Dust container release button
3. Pivot lock button
4. On/off switch
5. Container door
6. Container door release latch
7. Charging base
8. Flip-out brush
9. Dust collector extension
Assembly
Adjusting the dust collector (fig. A - C)
The dust collector (1) has a brush that can be folded forward
for dusting and upholstery cleaning.
The dust collector (1) is stored under the appliance. To
adjust for use, lift the appliance from the charging
base (7).
Press the pivot lock button (3) and rotate the dust
collector (1) to the required position.
Release the pivot lock button (3) to lock the dust
collector in position.
The dust collector can be extended by pulling the dust
collector extension (9) until it locks into position.
The extension can be retracted by pressing the button
(10) and pushing the extension back into the dust
collector.
The dust collector should be returned to the storage
position under the appliance after use and while
charging the appliance.
Residual risks
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks cannot be avoided. These include:
Injuries caused by touching any rotating/moving parts.
Injuries caused when changing any parts, blades or
accessories.
Injuries caused by prolonged use of a tool. When using
any tool for prolonged periods make sure you take
regular breaks.
Impairment of hearing.
Health hazards caused by breathing dust developed
when using your tool (example:- working with wood,
especially oak, beech and MDF).
Use
Before first use, the battery must be charged for at least
24 hours.
Place the appliance on the charging base whenever it is
not in use.
Charging the battery (fig. D)
Make sure that the appliance is switched off. The
battery will not be charged with the on/off switch (4) in
the on position.
Place the appliance on the charging base (7) as shown.
Plug in the charger. Switch on at the mains.
The charging indicator will be lit.
Leave the appliance to charge for at least 24 hours.
While charging, the charger may become warm. This is
normal and does not indicate a problem. The appliance can
be left connected to the charger indefinitely. The charging
indicator will be lit as long as the appliance is connected to
the plugged-in charger.
Warning! Do not charge the battery at ambient
temperatures below 4 °C or above 40 °C.
Switching on and off (fig. E)
To switch the appliance on, slide the on/off switch (4)
forward to position I.
To switch the appliance off, slide the on/off switch (4)
back to position 0.
ENGLISH
7
Tabla de contenido
