Tabla de contenido
Idiomas disponibles
Idiomas disponibles
11
5 Blade Installation
Remove rubber cushions, saving
motor screws for blade
installation. Using motor screws
(S5) provided, line up holes from the
blade arm with the holes in the motor
housing. Tighten screws securely.
12
12
Optional Light Kit Installation
Remove three screws from side of switch hub (as shown in figure
18
below). Remove hub cover from hub and pop out center plug.
Carefully thread wires from light kit through the center hole in hub
cover. At this point attach light kit into hub cover by screwing center
all-thread from light kit into the center hub cover. Lock the all-thread in
place on the inside of the hub using the 3/8" nut provided. Attach white
wire from light kit to white wire in hub, using wire nuts. Next, attach
black wire from light kit to blue wire in switch hub. Carefully push
wires up into hub and replace hub cover using screws removed earlier.
Screws
Center Screw
Step 11
Switch Hub
Center Plug
a
Optional Light Kit Installation for the 108
Remove three screws from side of switch hub (as shown in figure
below). Remove hub cover from hub. At this point attach white wire
from light kit to white wire in hub, using wire nuts. Next, attach
black wire from light kit to blue wire in switch hub. Carefully push
wires up into hub and replace kit with screws removed earlier.
13
Operation Instructions
1. The sequence of operation for the motor pull/chain switch is
OFF-HI-MED-LOW.
2. Push the slide switch RIGHT for FORWARD, and LEFT for
REVERSE action of the blades.
3. The pull chain switch for the lighting is two positions - ON/OFF.
Light Pull Chain
Slide Switch
CAUTION
Even if your fan is mounted with the blades more than 7 feet from the floor,
be careful to avoid placing your raised arms or any object in the path of the
Screw
Switch Hub
Hub Cover
Motor Pull Chain
Tabla de contenido
