DAB E.Box Manual Del Usuario página 10

GB
ENGLISH
completely free from traces of humidity, ox-
ide or dirt: if necessary, clean accurately
and check the efficiency of all the compo-
nents in the panel. If necessary, replace
any parts that are not perfectly efficient.
It is indispensable to check that all the panel
leads are correctly tightened in the respec-
tive clamps.
In the event of a long period of inactivity (or
when any component has been replaced),
it is advisable to perform on the panel all the
checks indicated by standard EN 60730-1.
Failure to observe the warnings may create situ-
ations of risk for persons or property and will void
the product guarantee.
RESPONSIBILITY
The Manufacturer does not vouch for
correct operation of the electropumps
or answer for any damage that they may
cause if they have been tampered with,
modified and/or run outside the recom-
mended work range or in contrast with
other indications given in this manual.
The Manufacturer declines all responsibility
9
for possible errors in this instructions man-
ual, if due to misprints or errors in copy-
ing. The Manufacturer reserves the right to
make any modifications to products that it
may consider necessary or useful, without
affecting their essential characteristics.
1. INSTALLATION
Strictly respect the electric supply val-
ues indicated on the electrical data plate.
- Although it has a grade of protection IP55,
it is not advisable to use it in an atmosphere
charged with oxidising or corrosive gases.
- The panels must be protected against the
direct rays of the sun and against unfavour-
able weather conditions.
- Use good quality cables with a section suit-
able for the current required by their motors
and for their length. Pay particular attention
to the power cable which must carry the
current for all the pipes connected.
- The sensors must be suitable for the place
in which they are positioned.
- It is necessary to take suitable steps to keep
the temperature inside the panel within the