Recommendedgroundingmethod; Electrical Requirements; Installing The Power Cord - Kenmore 580.75251 Manual Del Propietário

OBSERVEALL LOCAL CODESAND ORDINANCES.
DO NOT, UNDER ANY CIRCUMSTANCES,REMOVE
THE POWERSUPPLY CORD GROUND PRONG.
ELECTRICALGROUND IS REQUIREDON THIS
APPLIANCE.
For 230/208 volt 60 Hz,AC only, 15A fused and
properlygrounded electricalsupply is required.A time
delayfuse or time delay circuit breaker is
recommended.Use a dedicated circuit, serving only
this appliance.
DO NOT USE AN EXTENSIONCORD.
RECOMMENDEDGROUNDINGMETHOD
Foryourpersonal s afety,this appliance mustbe grounded.
This appliance hasa powersupplycordwitha 3-prong
grounding plug.Tominimizepossible shockhazard, t he
cordmustbe plugged intoa matinggrounding typewall
receptacle and grounded in accordance withthe National
Electrical C ode(ANSI/NFPA 70) latesteditionand all local
codesandordinances. I f a matingwall receptacle is not
available, i t isthe personal r esponsibility a nd obligation of
thecustomer to havea properlygrounded 3-prong wall
receptacleinstalled by a qualifiedelectrician.
115V ~
230V ~
Power cord may include a current interrupter
device. A test and reset button is provided on the
plug case. The device should be tested on a
periodic basis by first pressing the TEST button
and then the RESET button. If the TEST button
does not trip or if the RESET button will not stay
engaged, discontinue use of the air conditioner and
contact a qualified service technician.
NOTE: The shape may be different according to its model.
Use Wall Receptacle Power Supply
Standard 125V,
3-wire grounding
receptacle rated
15A, 125V AC
(_ Standard 250V,
3-wire grounding
receptacle rated
15A,250V AC
(_ Standard 250V,
3-wire grounding
receptacle rated
20A, 250V AC
Use 15 AMP. time
delay fuse or 15 AMP.
circuit breaker.
Use 20 AMP. time
delay fuse or 20 AMP.
circuit breaker.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
You can choose between two methods below according to your window sill shape and preference.
USING SLIT "A"
Fasten the stopper using 2 screw holes, and lead
out the power cord through slit "A".
-4-
USING SLIT "B"
Fasten the stopper using left screw hole, and rotate
properly to lead the power cord out through slit "B".
IE_ I.... ;_;;_ i_:_:_ _:_'_"_%'_'_'_'%;