Operational Safety; Operation And Safety - MetalTech JOBSITE 6 Serie Directivas De Seguridad E Instrucciones De Montaje

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

2

OPERATIONAL SAFETY

READ BEFORE BEGINNING ASSEMBLY.
FAILURE TO UNDERSTAND AND FOLLOW ALL SAFETY RULES AND ASSEMBLY INSTRUCTIONS COULD
RESULT IN SERIOUS INJURY OR DEATH.
METAL CONDUCTS ELECTRICITY:
Do not use this equipment where contact may be made with power lines or other live electrical circuits.
DO NOT OVERLOAD:
This scaffolding is designed to support a maximum load of 850 lb (385 kg). The maximum load capacity decreases when
stacking units: one unit high = 850 lb (385 kg) / two units high with guardrails = 650 lb (295 kg).
Per platform: 300 lb (136 kg). Per platform: 300 lb (136 kg)

OPERATION AND SAFETY

Do not use this equipment if you are in poor health,
taking medications, drugs, or have been consuming
alcohol, all of which may impair your ability to work
safely on this product.
Always use this scaffold in conformity with local or
national legislation which applies.
Inspect before use. Do not use scaffold if damaged
or parts are missing.
Examine thoroughly to make sure unit is properly set up.
Always use outriggers and safety rails when stacking
units.
Safety rails must be installed on all open sides of a
work platform where a person could fall from a height
of 6 ft (1.8 m) or more.
A safe working deck must have a minimum width of 18
inches (45.7 cm).
Do not climb unless all casters are in locked position.
Always climb up or down the scaffolding side frames
facing towards the ladder.
Always keep the body centered between the side
ALWAYS INSPECT
BEFORE USE
ALWAYS USE
OUTRIGGERS WHEN
STACKING UNITS
METAL CONDUCTS
ELECTRICTY
UNIT SHALL ONLY
BE USED ON
FIRM AND LEVEL
SURFACES
NEVER PLACE
ANYTHING UNDER
OR ATTACH
ANYTHING TO UNIT
All photos and drawings in this booklet are for reference purposes only. Refer to applicable OSHA, ANSI or CSA codes and regulations for the proper use of this equipment.
frame's uprights.
Always keep three points of contact with the ladder.
When climbing from the exterior, always step over the
ladder to access the platform.
Always keep the body close to the ladder as shown in
the "Maximum Climbing Distance" table.
Always keep a steady pace when climbing.
Do not create a swaying motion when climbing.
Erect to be plumb on firm and level surface.
This scaffold must be used on a firm surface that is
free of pits, debris, holes or obstructions.
Never place anything under or attach anything to this
scaffold to increase height or to adjust to uneven
surfaces.
Acids are corrosive and can seriously affect strength.
Do not expose this scaffold to corrosive substances.
Keep scaffold free of debris and unnecessary
equipment.
Always keep body centered inside structure of scaffold.
Remove or fasten all tools, material or equipment
ALWAYS LOCK
THE ALL CASTERS
BEFORE CLIMBING
SAFETY RAILS MUST BE
INSTALLED ON ALL OPEN
SIDES OF A WORK PLATFORM
WHERE A PERSON COULD
6'
FALL FROM A HEIGHT
(1.8 M)
OF 6 FT (1.8 M) OR MORE
ALWAYS KEEP BODY
CENTERED INSIDE
STRUCTURE OF UNIT
NEVER TRY MOVING
THE UNIT WHILE
STANDING ON IT
DO NOT USE
THE UNIT AS
A FOOTBRIDGE
before moving. Use extra caution when moving to
avoid tipping.
Never try moving this scaffold while standing on it.
Never move a scaffold with a worker within.
Do not use powered devices to propel this scaffold.
Use extra caution near operating machinery.
Do not use if the surface is not firm and level.
Do not use in inclement weather or high winds.
Maintain a firm grip while climbing.
Do not modify the scaffold or any of its components.
Do not use the scaffold as a footbridge.
SCAFFOLD
MAXIMUM LOAD
CAPACITY:
MAX
850 lb (385 kg)
300 lb PER
MAX. 850 lb
(385 kg)
PLATFORM (136 kg)
ALWAYS CLIMB
UP OR DOWN THE
SCAFFOLDING SIDE
FRAMES FACING
TOWARDS THE
LADDER.
DO NOT USE IN
INCLEMENT WEATHER
OR HIGH WINDS
ERECT ON FIRM
AND LEVEL GROUND
REMOVE OR FASTEN TOOLS,
MATERIAL OR EQUIPMENT
BEFORE MOVING. NEVER
MOVE A SCAFFOLD WITH
WORKER WITHIN.
MAX
ALWAYS KEEP THE
BODY CLOSE TO THE
LADDER AS SHOWN
IN THE "MAXIMUM
CLIMBING DISTANCE"
TABLE.
DO NOT CREATE A
SWAYING MOTION
WHEN CLIMBING.
ACIDS ARE CORROSIVE.
DO NOT EXPOSE
UNIT TO CORROSIVE
SUBSTANCES
Tabla de contenido
loading

Este manual también es adecuado para:

I-ircI-irex3

Tabla de contenido