Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
4. Cabinet Installation
The wall oven can tip when the door is
open. The anti-tip brackets supplied with the wall
oven must be attached to the cabinet and the
appliance to prevent tipping of the wall oven and
injury to persons.
Anti-Tip Brackets Installation Instructions
1.Unpack the wall oven and find the 2 anti-tip brackets
and screws included in the literature package.
2.Install the anti-tip bracket in the cabinet as shown on
figure 4. Note: To prevent damage to cabinet, it is
recommended to drill 1/16" (0.16 cm) dia. pilot holes
before installing the anti-tip brackets.
Cutout Dimensions
28 1/2" (72.4 cm) Min.*
29" (73.7 cm) Max.*
Anti-Tip Brackets
23 1/2"
(59.7 cm)
* Recommended Cutout Width is 28 1/2" (72.4 cm)
Figure 4
3.Insert the unit into the cabinet opening. Slide unit inward
leaving 1 1/2" (3.8 cm) clearance between the oven and
front of cabinet (see Figure 5). Pull the armored cable
through the hole in the floor and toward the junction box
while moving the appliance inward.
4.Push the unit in and against the cabinet, then the oven
side bracket will clip in the one you just install on the side
of the cabinet opening (see figure 6).
To pull out the oven for servicing insert the tool supplied
with the appliance both side at the same time in the hole
located on the side frame and visible when the door is
opened. After inserting the tool pull the oven towards
you (see figure 7).
5.For typical under counter installation of an electric built-in
oven see Figure 8.
28 1/8"
(71.4 cm) Min.
28 7/8"
(73.3 cm) Max.
4
Figure 5
Figure 6
Anti-tip bracket
installed in cabinet
Oven
Bracket
Cabinet
Anti-tip
Oven
bracket
released
Right Side
Tool supplied
Figure 7
1 1/2" (3.8 cm)
clearance
between unit
Oven removed
from the cabinet
Tabla de contenido
