MaxPro MPDH1500 Manual De Instrucciones página 7

D D emolition Hammer MPDH1500 User Manual
screw is tight.
2. This electric hammer chisel has a fixed handle always make sure the screws holding the handle are
secure before operation takes place. Always use both hands when using this chisel failure to adhere to this
could invite injuries.
3. Safe operation, always make sure you have a stable posture and safe footing before operating the
electric hammer chisel.
4. When working at a high level, always make sure that no person or persons are below you, as this could
invite injuries to those persons under you.
5. Before starting any job like breaking, chipping a wall, floor or ceiling, thoroughly confirm that no items
such as an electric cable, water pipe or conduit are buried inside as this could cause injury or flooding.
6. Properly set the bit holder.
7. The bit can become very hot during operation exercise extreme caution as this could cause injury.
8. Always wear protective safety glasses
9. Always wear ear defenders or earplugs
10. Always wear suitable dust mask
11. Always wear protective footwear.
12. Always wear hardhat
Information on how to use the electric hammer chisel
Prior to operation
1. Power source
nameplate.
2. Power switch
Ensure that the power switch is in the off position before any work is carried out on the chisel. If the plug is
connected to a power receptacle while the power switch is in the on position, the power tool will start
operating immediately this could invite serious injury.
3. Extension cord.
When the work area is away from the power source, use an extension cord of sufficient thickness and
rated capacity. The extension cord should be kept as short as practicable
How to use the electric hammer chisel
Place the bit you are going to use to do the job in hand as in Fig 3 and 4 page 10
(1) Pull the trigger switch after applying the chisel bit tip to the chiseling position.
(2) It may be necessary to punch the bit against the crushing position forcibly in order to begin the striking
stroke. This is not due to malfunction of the tool, it means that the safe guard mechanism against no-load
striking is working.

can effectively control the subsequent recoil motion. (See Fig 5)
7
GB