MaxPro MPDH1500 Manual De Instrucciones página 6

D D emolition Hammer MPDH1500 User Manual
3
WARNING
The electric hammer chisel continues for a few second after the trigger has been release, be careful when
putting it down.
Fitting a chisel bit into the Hex housing
To insert the bit, hold the front cover rotate the stop lever 180º as arrow 2 in a clockwise direction as
arrow 1, while pulling the stop lever towards you, Insert the bit you want to use to the hex housing, the
shank of the bit has a cut out hold the bit with its flattened part upwards, push the bit into the hex housing
as arrow 3
4
Put the bit into the hex housing and clamp the bit by turning the stop lever half a turn anti clockwise. This
will lock the bit in place.
5
Do not use the chisel until you are satisfied the bit is secured.
This electric hammer chisel does not have reverse direction, so always take care not to force the chisel in
case the chisel bit gets stuck. Always make sure you keep the chisel going in and out to remove debris.
This chisel does not have torque facility. It is not recommended to use any other bit other than
masonry or chisels do not use metal cutting drills, this could cause serious injury
NOTE: chiseling for an extended period of time may cause the chisel motor to overheat. If the chisel gets
hot, stop chiseling and allow it to cool for at least 15 minutes.
Precautions on using electric hammer chisel.
1. Before using the electric hammer chisel always makes sure the oil supply is to the full level and the
6
GB