Important Points - STEINEL Gluematic 3002 Instrucciones De Uso

Gluematic3002-24spr.qxd
Operating Instructions
GB
í Install metal support
stand. Insert glue stick
(45, 90 or 200 mm).
í Place glue gun on metal
support stand. Place a
cardboard or wood pro-
tective surface under glue
nozzle, if necessary.
í Plug glue gun in. Allow to
heat up for approximately
7 minutes.
í Pull trigger to apply glue
to one side.
í Press with force on the
material being glued and
adjust if necessary.

Important points

í Check the glue gun for
damage before switching
it on (mains connection
lead, housing, etc.) and
do not use if damaged.
í Repairs must only be
performed by a qualified
electrician.
í A problem-free function-
ing is only guaranteed if
STEINEL and/or Henkel
glue sticks are used.
í Do not use liquid or paste
glues!
í Since the glue gun ope-
rates up to 200° C/392° F,
exercise caution when
using.
í Only use the glue gun in
dry rooms.
í Do not use in conjunction
with highly flammable/
combustible substances.
í Do not leave the glue gun
unattended.
í Keep it out of the reach
of children.
08.05.2008 16:30 Uhr
í After approximately 2 min., í After use, return gun to
the glued objects are fully
secured.
í Spot glueing is recom-
mended for large or long
surfaces.
í Foam products (i. e.
styrofoam) can also be
glued successfully, pro-
viding that foam has a
protective or decorative
veneer. (Do not apply
glue directly on foam.)
í For glueing of textiles or
similar materials, apply
glue in a snake-like
(weaving) pattern.
í The parts to be glued í Pressing too hard may
must be free of grease,
dry and absolutely clean.
í When glueing process is
interrupted for more than
thirty minutes, turn off
glue gun by pulling out
electrical plug.
í Protruding glue can easily
be removed with a warm
knife. Always discon-
nect the mains plug
first.
í When using our "super- í
sticks", residual glue can
be removed with heat or
painted over.
í Small drops of glue can
í Gluematic 3002:
be easily removed when
cold.
í When introducing new
glue sticks please wait a
moment so that the cold
cartridge can be warmed
up. Under no circum-
stances push in with
force.
Seite 7
stand and allow to cool.
jam the glue stick feeder
inside the applicator... If
this happens, heat the
applicator for about 10
min. and pull 3 – 5 mm of
the glue stick out of the
nozzle... if the glue stick
is too far in, heat a new
stick at the tip of the ap-
plicator, fuse it with end
of the jammed glue stick
and carefully pull forward.
Do not pull the glue
stick all the way out
of the applicator. Hot glue
running into the applica-
tor can cause damage.
After changing nozzle,
always make sure it is
screwed on tightly
(approx. 1 Nm).
5