Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
1
Installing the doorbell
□
Plug in the doorbell (A) at the desired location.
2
Testing the push button and
doorbell
□
Temporarily position the push button (B) where
it will be mounted.
□
Press the push button (B) to verify the
doorbell (A) and push button (B) work properly.
□
If the doorbell (A) does not sound, move the
doorbell (A) closer to the push button (B) and
test again.
NOTE: Do not permanently mount the push button until
the push button and doorbell are working properly.
3
Mounting the push button
Use either screws (AA) or double-sided tape (BB) to
mount the push button (B).
□
To mount with screws (AA), remove the back
of the push button (B) by pushing in the tab
on the bottom with a small screwdriver (not
included). Place the push button back on the
door jamb and mark the two screw holes. Drill
two 1/16 in. pilot holes. Attach with screws
(AA) and snap on the front of the push button
(B).
□
When attaching the push button (B) with
double-sided tape (BB), remove the paper from
both sides of the double-sided tape (BB) and
apply to a clean surface.
NOTE: Remove material in screw holes (if needed) before
mounting with screws.
A
NOTE: The push button and doorbell come synced from
the factory. The range of the wireless doorbell can vary
with location and temperature.
B
AA
5
Please contact 1-844-760-3644 for further assistance.
A
B
HAMPTONBAY.com
Capítulos
Tabla de contenido
