Ladder Modification (Optional); Ladder Assembly - Tripp-Lite SmartRack SRCABLELADDER Manual Del Propietário

3 – Installation

3-2 Ladder Modification (Optional)

Warning: When using tools to cut or drill metal, use eye protection and follow all other safety precautions recommended by the tool
manufacturer and required by applicable safety regulations. Use caution and wear safety gloves when handling metal parts that have
been cut to length. Sharp edges can cause personal injury and property damage.
Note: Do not modify the SRCABLELADDER accessory unless you have followed the instructions in Section 3-1 Planning and determined that
modification is required. If modification is not required, proceed to Section 3-3 Ladder Assembly.
1
Measure and mark the cable ladder section that will be cut.
2
Use a hacksaw or other metal-cutting tool to cut through the ladder section. Make sure your cut is perpendicular to the length of the ladder
and use a metal-cutting tool that will not bend or crush the ladder section.
3
(Optional) After cutting, use a drill with a 3/8-inch bit to drill new pin holes in end of the ladder section. Compare the modified end of the
ladder section with the unmodified end to determine where holes should be drilled. Make sure that the hole location matches your planning
and measurements. You may omit this step, but drilling the pin holes and installing the pins will make the SRCABLELADDER accessory
more stable.

3-3 Ladder Assembly

1
Assemble the two ladder clamps
, washers and hex nuts
B C
only tighten the nuts far enough to keep the clamps assembled
together.
2
Join the ladder sections
clamps until they are stopped by the bolts
A
are joined, you can now secure the clamp by fully tightening the
nuts.
201105211 93-2973.indb 4
(continued)
with the M10 carriage bolts
A
as seen in the diagram. For now,
D
by inserting each side into the ladder
E
. When the sections
B
B
A
C
D
1
E
B
2
4
X2
A
E
5/23/2011 12:56:45 PM