Bosch DHG6003UC Instrucciones De Instalación página 2

Ventilador de techo o pared
Idiomas disponibles

Idiomas disponibles

Figure 2 CURB FOR ROOF
Figure 5
MODEL
A
DHG6003UC 8" Dia.
DHG1003UG 10" Dia.
PAINTING THE BLOWER
This unit is finished with zinc galvanized coating per ASTM
(American Society for Testing and Materials) A525 Coating
Disintegration GT90. This coating provides a good level of
corrosion protection and can be painted, if desired.
Before painting, the unit must be thoroughly cleaned with a
solvent or with soap and water and dried. A metal primer such
as Rust-Oleum® is needed for good paint adhesion. Almost
any outdoor paint can be used over the primer.
If you have questions about painting galvanized metal, consult
a local paint dealer.
KITCHEN VENTILATION TIPS
1. Cooking Appliances such as Ranges, Cooktops, Barbecue
Units, Grills, etc., require adequate ventilation. Hood
should be large enough and Cooking Appliances located so
that the Hood overhangs the Cooking Surface as much as
possible.
2. Consult a Competent Kitchen Designer or Ventilation
Engineer for proper Hood size and C.F.M. requirements.
3. Provide make-up air input to the kitchen so exhausted
air is not drawn through furnace unit or down fireplace
chimney.
4. Locate the Cooking Area for minimum cross drafts, away
from doors and windows, etc., when possible.
5. For best performance duct runs should be as short and
as straight as possible. Where turns are necessary, keep
turning radius as large and as smooth as possible.
Figure 3
TYPICAL INSTALLATION USING BOSCH HOODS
B
C
8" Dia.
10-3/8
11-1/2
10" Dia.
10-3/4
10-1/4
Figure 6 – Remote Blower Dimensions
D
E
F
4-5/8
14-7/8
3-1/8
17-5/8
WARNING – TO REDUCE THE
RISK OF A RANGE TOP GREASE
FIRE:
a) Never leave surface units unattended at high
settings. Boilovers cause smoking and greasy
spillovers that may ignite. Heat oils slowly on low or
medium settings.
b) Always turn hood ON when cooking at high heat or
when flambéing food (i.e. Crepes Suzette, Cherries
Jubilee, Peppercorn Beef Flambé).
c) Clean ventilating fans frequently. Grease should not
be allowed to accumulate on fan or filter.
d) Use proper pan size. Always use cookware appro
priate for the size of the surface element.
Warning: In case of cooktop fire, do not operate
blower.
Caution: Grease left on filters can remelt and move
into the vent.
Figure 4
G
H
I
8-3/4
8
24
10-3/4
10
26-1/4
J
3-1/2
4
loading

Este manual también es adecuado para:

Dhg1003uc