Ace ACE5S 1/2 HP Manual Del Usuario página 6

Installation
18. Cement as many sections and couplings of rigid 1" PVC pipe
needed to connect the 1" male PVC adapter in the discharge
tee to the 1" male adapter on the tank cross inlet. Set
pressure in the pre-charged pressure tank to 2 pounds less
than the cut-in pressure of the pump. If the cut in pressure
is 30 PSI, then the correct tank pre-charge is 28 PSI. If the
cut in pressure is 20 PSI, then the correct tank pre-charge
is 18 PSI. Total installation should look like the shallow well
drawing below.
19. Open a faucet or two in
the house. Start motor. If
pump is offset from well 4
feet or more, it may take a
few minutes for pressure
to build. If pressure fails to
build within five minutes:
Stop motor, remove pressure
gauge plug from discharge
tee, add more water, try
again.WELL POINT PUMP
INSTALLATION
ACE5S and ACE10S
Shallow Well
ACE5C and ACE10C
Convertible
Materials needed in addition to Shallow Well General
Materials, for Well Points only
• Enough galvanized 1-1/4" pipe and drive couplings to reach
from operating depth to one foot above ground level
• One 1-1/4" galvanized elbow
• One 1-1/4" galvanized nipple
• One 1-1/4" check valve
• One 1-1/4" male PVC adapter
• One drive cap
STEP 1: Drive the well point into the ground according to
the instructions included with your well point. Use as much
galvanized pipe and as many drive couplings as it takes to
both drive the point 5-10 feet below the water table and leave
approximately one foot of pipe protruding from the ground.
STEP 2: Thread 1-1/4" galvanized elbow onto the pipe protruding
from the ground.
STEP 3: Thread 1-1/4" galvanized nipple into the 1-1/4" galvanized
elbow.
STEP 4: Thread 1-1/4" check valve onto the 1-1/4"
galvanized nipple.
STEP 5: Thread 1-1/4" male PVC adapter into the 1-1/4"
check valve.
7164 0117
STEP 6: FOLLOW STEPS 6–19 IN SHALLOW WELL
INSTRUCTIONS. Total installation should look like the drawing
below.
6116 1109
6
6117 1109