K2 Pumps WPS05001K Manual Del Propietário página 9

Install a 1in.×3/4in.PVC Male Adapter to the
6.
galvanized tee. (Fig. 6)
Remove the 1/8" NPT pipe plug from the pump Air
8.
Volume Control (AVC) port. Near the top tapping of the
pump face, thread a 1/8 in barbed barb x MIP adapter
fitting into the pump's AVC port .Run tubing from the
pump's AVC port to the port on the AVC mounted on
the tank. You have just completed the tank connection
for your shallow well jet pump. (Fig. 8)
NOTE: As the pump refills the tank with water, the air
volume control supplies the tank with the correct air to
water ratio for the system to operate. If the air volume
control is good, the pump will shut off at the desired
cut-off setting and will be adjusted correctly.
PUMP ELECTRICAL CONNECTIONS
WARNING: Risk of electric shock. Can shock, burn or kill. Disconnect power
before working on pump, motor, pressure switch, or wiring.
To change from 230V to 115V
WPS05002K/ WPS07502K
The motor is 115/230 Volt single phase. This pump has built- in automatic
dual-voltage selector switch and voltage can be converted automatically. No
change need
WPS05001K / WPS07501K
The motor is 115/230 Volt single phase and pre-wired at 230 volts.
If the power supply is 115 volts, remove the rear cover of motor.
Slide the switch to show 115 Volt.
Replace the rear cover of motor.
WARNING: Risk of electric shock. Can shock, burn or kill. Be sure power is off.
Never connect a motor set to 115 V to a 230 V power supply.
For Professional Technical Support call 1-844-242-2475
Install a short 3/4in.PVC rigid Pipe，Then completed
7.
installation with piping and tank is shown (Fig. 7)
9