Taurus HIGH LANDSCAPES Manual De Instrucciones página 9

- Respect the legal provisions concerning safety
distances from other elements such as pipes,
electrical connections, etc.
- Ensure that the appliance is level with respect
to the floor.
- The appliance requires suitable ventilation in
order to work properly. Leave a space of 150
cm between walls or other obstacles..
- Do not cover or obstruct any of the openings of
the appliance.
- The plug must be easily accessible so it can be
disconnected in an emergency.
INSTRUCTIONS FOR USE
BEFORE USE:
- Remove the appliance's protective film.
- Make sure that all the product's packaging has
been removed.
- To eliminate the smell given off by the applian-
ce when used for the first time, it is recommen-
ded to have it on at full power for 2 hours in a
well-ventilated room.
- Prepare the appliance according to the function
you wish to use:
INSTALLING THE PRODUCT
- Pull the rear cover handle to remove it (FIG1)
- Remove the plastic package from the filter.
(FIG2)
- Install the filter into the machine (FIG3)
- Fasten up the rear cover and connect to the
power source (FIG4)
USE:
- The appliance can be used directly connected
to the main.
- Extend the cable completely before plugging
it in.
- Attach the appliance to its base / connector
making sure that it is correctly fitted into place.
- Connect the appliance to the mains.
- Guide the appliance to direct the flow of air in
the desired direction.
- Turn the appliance on, by using the on/off
button.
- Select the appliance function desired.
- Select the desired speed.
TIMER FUNCTION:
- The appliance's operating time can be control-
led.
- Press and hold button (6) for 5 seconds
to activate the Timer. The time will be di-
splayed on the screen and switch between
1h/2h/4h/8h/0(cancel timing), the required time
is set when stop pressing
FAN SPEED MODE
Cycles through fan speeds:
AUTO MODE
- Auto Mode uses the sensor inside the air puri-
fier to adjust the fan speed automatically based
on air quality.
- For example, if the air quality is bad, the fan will
automatically be set to highspeed.
SLEEP BUTTON
- Tap this button (1), to turn Sleep Mode on/off.
- Sleep Mode operates quietly by using the
lowest possible fan speed, all indicators except
sleep indicator will be off.
- Tapping any key, the display will resume for
30 seconds, and then tap sleep button or fan
button within 30 seconds to exit sleep mode
and enter the auto mode.
- After 30 seconds without button operation, the
display will be off.
LOCK/UV-C BUTTON
- The UV-C button is combined with child lock
button.
- Tap this button to turn the UV-C on/off. When
the UV-C is turned on, the status indicator
lights up, otherwise it turns off.
- For the safety use of UV, when the filter cover
is opened, the UV-C LED will shut off automa-
tically and the appliance stops working as well.
Please always use the appliance with the filter
inside.
- Press and hold this button for 5 seconds to ac-
tivate the child lock function, and the indicator
is displayed on the lower right corner of the
screen.
FILTER REPLACEMENT
- When the filter life expires (about 3000 hours
of life time) the filter replacement indicator will
blink red to remind you.