Appropriate Installation Location; First Use - Ansonic SAC137 Manual Del Usuario

2
Installation
Refer to the nearest Authorised Service Agent for
installation of your product.
C
Preparation of location and electrical installation for the
product is under customer's responsibility.
B
Installation and electrical connections must be carried
out by a qualified personnel.
A
Prior to installation, visually check if the product
has any defects on it. If so, do not have it installed.
Damaged products will cause risks for your safety.

Appropriate installation location

• Install the product in an environment which has no
risk of freezing and is in a stable and level position.
• Operate your product in a well ventilated, dust-free
environment.
• Do not block the air ducts in front of and under the
product with materials such as long pile rugs and
wooden bands.
• Do not place your product on a long pile rug or on
similar surfaces.
• Do not install the product behind a door with a lock,
sliding door or a hinged door which can strike the
product.
• Once the product is installed, it should stay at the
same place where its connections have been made.
When installing the product, make sure that the rear
wall of it does not touch anywhere (tap, socket, etc.)
and also pay attention to install the product at a place
where it will stay permanently.
B
Do not place the product on top of the power cable.
• Keep at least 1.5 cm distance to walls of other
furniture.
Removing the transportation safety
assembly
A
Remove the transportation safety assembly before
using the product for the first time.
1. Open the loading door.
2. There is a nylon bag inside the drum that contains a
piece of styrofoam. Hold it from its section marked
with XX.
3. Pull the nylon towards yourself and remove the
transportation safety assembly.
A
Make sure that you have removed the transportation
safety assembly (nylon+styrofoam pieces) before
using the product for the first time. Do not leave any
items inside the drum.
Under counter installation
• A special part (Part no. 297 360 0100) replacing
the top trim must be provided and installed by the
Authorised Service Agent in order to use the machine
under a counter or in a cupboard. It should never be
operated without the top trim.
• Leave at least 3 cm of space between the side and
rear walls of the product and the walls of the counter/
cupboard when installing your product under a counter
or in a cupboard.
Mounting over a washing machine
• A fitting device should be used between the two
machines when installing above a washing machine.
The bracket (Part no. 297 720 0200 white/297 720
0500 grey) must be installed by the Authorised Service
Agent.
• Place the product on a firm floor. If it will be placed on
top of a washing machine, the approximate weight of
both machines may reach 180 kg when they are full.
Therefore, the floor must be capable of carrying the
load on it!
Adjusting the feet
In order to ensure that your machine operates more silently
and vibration-free, it must stand level and balanced on its
feet. Balance the machine by adjusting the feet.
Rotate the feet to adjust until the machine stands level and
firmly.
C
Never unscrew the adjustable feet from their housings.

First use

• To have the product ready for operation before calling
the authorised service agent, make sure that its
location and power supply installations are appropriate.
If they are not, call a qualified electrician to have any
necessary arrangements carried out.
• Make sure that the power connections of the product
are in accordance with the instructions given in
relevant chapters of this manual.
5 EN