HAMPTON BAY HB-7733-03 Guía De Uso Y Cuidado página 5

Installation (continued)
Testing the doorbell and push
3
button placement
Temporarily position the push button (B) and
doorbell (A) where they will be mounted.
Press the push button (B) to verify the
doorbell (A) and push button (B) work properly.
If the doorbell (A) does not sound, move the
doorbell (A) closer to the push button (B) and
test again.
NOTE: Do not permanently mount the push button (B) or
doorbell (A) until they are working properly.
4
Mounting the push button
Use either screws (AA) or double-sided tape (CC) to
mount the push button (B).
To mount with screws (AA), remove the back
of the push button (B) by pushing in the tab
on the bottom with a small screwdriver. Place
the push button back on the door jamb and
mark the two screw holes. Drill two 1/16 in.
(1.5 mm) pilot holes. Attach with screws (AA).
When attaching the push button (B) with
double-sided tape (CC), remove the paper from
both sides of the double-sided tape (CC) and
apply to a clean surface.
Snap on the front of the push button (B).
5
Mounting the doorbell
Use the screws (AA) to mount the doorbell (A).
Determine mounting location.
Mark two level points 3.0 in. (7.6 cm) apart on
the mounting surface.
Drill two 7/32 in. (5.5 mm) pilot holes and
insert the wall anchors (BB).
Insert the screws (AA) into the wall
anchors (BB) leaving about 1/8 in. (3.2 mm) of
the screw threads exposed.
Hang the doorbell (A) on the screws (AA) using
the keyholes on the back of the doorbell (A).
NOTE: The push button and doorbell come synced from
the factory. The range of the wireless doorbell can vary
with location, temperature, and battery condition.
B
NOTE: Remove material in screw holes (if needed) before
mounting with screws.
AA
A
BB
AA
5
Please contact 1-844-760-3644 for further assistance.
A
HAMPTONBAY.com