Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Clip
Cross Rail
1. Install Legs (Single Vanity Installation)
IMPORTANT! Legs are not required for installation between two
vanities.
NOTE: To protect the finished surface of the cabinet, perform
assembly tasks on a flat, padded work surface.
Place the cabinet upright on a flat, padded surface.
Remove the drawer to access the holes for leg attachment. Refer
to the "Remove/Reinstall the Drawer" section of this guide.
Determine whether the legs will be installed on the left or right.
The opposite side will be supported when installed to the K-2604
vanity.
Lay the cabinet on its side and position each leg so the clips face
toward each other (as shown).
Secure each leg post using two #8 x 2" panhead screws, lock
washers, and flat washers.
Position the cross rail above the clips between the front and back
legs (as shown).
Evenly press down on the cross rail until the clips are fully
engaged. You may need to apply slight pressure on each end
until it clicks in place.
Kohler Co.
Rear Leg
Screw
Clip
3
Front
Leg
1207227-2-A
Tabla de contenido
