Conveyor Set-Up
Re-check the "match-mark" numbers to see that adjoining
sections are in proper sequence and follow these steps
below to set up the conveyor.
1. . .
Mark a chalk line on floor to locate center of the con-
veyor. (Floor Mounted Conveyors).
2. . .
Place the drive section in position.
3. . .
Install remaining sections placing end without support
on extend pivot plate of previous section (Figure 7B).
4. . .
Connect V-belts per instructions on Page 8.
5. . .
Fasten sections together with butt couplings and
pivot plates (Figure 7A). Hand tighten bolts only at
this time.
6. . .
Check to see that all "ACC" bed sections are square.
Refer to Page 10 for Instructions on How To Square
The Beds.
7. . .
Spurs (LRS or LRSS) are attached to side of ACC
with "K" brackets as shown in Figure 8A.
8. . .
Curves (LRC) or spurs that have no drive may be
slave driven from ACC. See Page 11 for instructions
on connecting the drive chain.
FIGURE 7A
SIDE CHANNEL
(CANAL LATERAL)
MOUNTING BOLT
(TORNILLO DE MONTAJE)
FIGURE 7B
CENTER DRIVE
SECTION
(SECCION DE LA
UNIDAD MOTRIZ)
"ACC"
Revise las Etiquetas de Secuencia de Armado para asegu-
rarse que las secciones estén unidas en el orden correcto y
tome los siguientes pasos para armar el transportador.
1. . .
2. . .
3. . .
4. . .
5. . .
6. . .
7. . .
8. . .
INTERMEDIATE OR
TAIL SECTION
(SECCION INTERME-
DIA O DE RETORNO)
"MATCH-MARK"
NUMBERS
(ETIQUETAS
DE ARMADO)
"LRC"
Montaje del Transportador
Marque con tiza una línea en el suelo para ubicar el
centro del transportador.
Coloque la sección motriz en posición.
Instale las secciones restantes, colocando el extremo
sin soporte en la placa pivote del soporte de la sec-
ción anterior (Figura 7B).
Conecte las Bandas-V usando las instrucciones de la
página 8.
Asegure las secciones con placas de unión y placas
pivote (Figura 7A). Apriete los tornillos manualmente.
Verifique que todas las secciones de cama "ACC"
estén escuadradas. Vea la página 10 para
instrucciones de como escuadrar las camas.
Las espuelas (LRS o LRSS) se fijan a un lado del
ACC con abrazaderas "K" como se muestra en
Figura 8A.
Las curvas (LRC) o espuelas que no tienen unidad
motriz pueden ser impulsadas por modelos ACC. Vea
las instrucciones en la página 11 para instrucciones
de como conectar la cadena motriz.
SIDE CHANNEL
(CANAL LATERAL)
BUTT COUPLINGS
(ACOPLES DE EXTREMO)
PIVOT PLATE
(PLACA PIVOTE)
STATIONARY SUPPORT
(SOPORTE ESTACIONARIO)
MATCH
CENTER
MARKS
SUPPORTS
(ETIQUETAS
(SOPORTE
DE ARMADO)
CENTRAL)
END
GUARD
(GUARDA DEL
EXTREMO)
7