Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2. Mount Solar Panel. Allow for enough wire to reach
the battery case. Attach triangular base to a solid
surface using three tapered screws. IMPORTANT:
Caulk around the base and on top of the tapered
screw heads after installation.
Note: See Initial Battery Charge and illustration on
next page for solar panel setup information.
Caulk Base Edges
Three Mounting Holes for Solar Panel Base
Mounted Solar Panel
Note: Solar panel should be mounted as shown above
when installed (depending upon type of installation).
After adjusting solar panel, tighten the thumbscrew on
the bottom of the solar panel.
Caulk All Mounting
Holes (3)
Ball Joint
Angled 50°
roof Mount
Wall Mount
Angled 50°
3. Mount Light Fixture. Attach the battery case to a
solid surface using two round-head screws and the
keyholes on the back of the case.
Note: Use the included mounting template to help
mark the mounting hole locations.
Wall Mounted Light
Note: Light fixture and sensor should be mounted as
shown above when installed (depending upon type of
installation).
Do not Mount under eaves
2
Mounting
5
/
"
3
Holes (2)
4
Solar Panel
Solar Panel
Wire
Light Fixture
598-1344-03
Tabla de contenido
