Using The Laser; Operating Tips - Stanley STHT77504-1 Manual De Instrucciones

11.
If your measurement is greater than the
GB
Allowable Distance Between
corresponding Height
the laser must be serviced at an authorized
service center.
Height
D
6.56' (2.0m)
8.20' (2.5m)
9.84' (3.0m)

Using the Laser

Operating Tips

• Always mark the center of the beam created by
the laser.
• Extreme temperature changes may cause
movement of internal parts that can affect accuracy.
Check your accuracy often while working.
• If the laser is ever dropped, check to make sure it
is still calibrated.
• As long as the laser is properly calibrated, the
laser is self-leveling. Each laser is calibrated at
the factory to find level as long as it is positioned
on a flat surface within average ± 4° of level. No
manual adjustments are required.
• Use the laser on a smooth, flat, level, surface.
Turning the Laser Off
Slide the Power/Transport Lock switch to the OFF
position (Figure
A 2
the switch is not placed in the OFF position, the laser
will not turn off.
12
and for the
e f
in the following table,
D
Allowable Distance
Between and
e
1/16" (1.5mm)
3/32" (2.0mm)
1/8" (2.5mm)
) when the laser is not in use. If
Using the Laser with the Bracket
A bracket (Figure
you can easily attach the laser to a stud, ceiling grid,
or pole.
1.
Securely attach the laser to the bracket.
• Using the 1/4-20 thread on the bottom, side,
f
or back of the laser (Figure
laser on the 1/4-20 thread on the bracket arm
(Figure
• Turn the laser knob (Figure
to lock the laser on the 1/4-20 thread on the
bracket arm.
2.
If needed, change the height or position of the laser
on the bracket.
• Turn the adjustment knob (Figure
clockwise to loosen the bracket arm.
• Slide the bracket arm up or down to the desired
height (Figure
from 90° to 180°, slide the bracket arm to the
top of the bracket and then flip the arm to the
right (Figure
• Turn the adjustment knob (Figure
clockwise to lock the bracket arm in place.
3. Use the bracket's clamp (Figure
laser in place on a stud, ceiling grid, or pole.
• If necessary, rotate the clamp so it is positioned
at the correct angle for attaching to the object.
While holding the bracket arm with one hand,
use your other hand to turn the clamp (Figure
G 7
• Position the bracket's clamp around the stud,
ceiling grid, or pole.
• Turn the clamp knob (Figure
until the clamp is tight around the object and the
bracket is held in place.
) is included with the laser so
G
), position the
C
).
G 1
G 2
). To change the bracket
G 4
).
G 5
G 6
).
G 8
) clockwise
) counter-
G 3
)
G 3
) to hold the
) clockwise