Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Connecting the Subwoofer to Stereo or Dolby
For stereo or Dolby Pro Logic systems, the easiest method is to use the same speaker wire connections as shown on page 5.
You may also use the "sub out" connection from your receiver to the input on the subwoofer marked use crossover control.
When using speaker wire or the use "crossover control" input, the subwoofer's built-in crossover is engaged. As a starting
point, set the crossover control on the subwoofer about 10Hz higher than the lower limit of your main speakers' bass response
(for Boston Acoustics front speakers, refer to the included "Optimal Crossover Settings..."sheet). Fine-tune the crossover set-
ting by ear for the smoothest blend with your main speakers. The best setting of the crossover control will depend on speak-
er placement and personal preference.
XB4
Powered Subwoofer Featuring BassTrac
* use crossover control: removes high
frequencies; use with sources lacking suitable
filtering (most products without Dolby Digital
or THX), or where manual control is desired.
** bypass crossover control: direct to woofer;
use with sources having built-in crossover
controls or bass management (most products
with Dolby Digital or THX).
CAUTION: Disconnect supply cord
before replacing fuse. For continued
protection against risk of fire, replace only
with same type fuse.
ATTENTION: Debrancher avant de
remplacer le fusible. Utiliser un fusible de
rechange de même type.
120V ~ 60Hz 1.25A
T 1.5A L 250V
Controls
Volume (on top panel): Adjusts the sound level of the subwoofer. A typical setting is around
11 o'clock.
Crossover (Hz): Adjusts the frequency of the lowpass filter for the
subwoofer. This control is inactive when using the "bypass crossover
control" input jack.
Polarity (0° or 180°): Selects regular (0°) or inverted (180°) polarity for the subwoofer.
Set this switch to provide the fullest, most dynamic bass. The effect of phase will be
most audible on low-frequency percussion instruments or music with a continuously
repeating bass line.
Power light and power status: The power light turns on whenever the XB4 is plugged into an
electrical outlet. The XB4's auto-on circuitry turns the subwoofer on when a signal is presented, and
turns it off if no signal is detected. NOTE: Power is always supplied to the subwoofer electronics
unless it is unplugged. The auto-on circuitry only activates or deactivates the power amplifier.
®
power
line level in
100
125
use
bypass
crossover
crossover
control *
control **
0 º
75
150
180 º
crossover
(Hz)
polarity
speaker level in
left
right
CAUTION
RISK OF ELECTRIC SHOCK
DO NO T OPEN
C
US
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
6
®
Pro Logic
®
subwoofer out
back of receiver
100
125
75
150
crossover
(Hz)
polarity
Systems
0 º
180 º
power
Tabla de contenido
