Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
E-WKL Series
10,000L LED Portable Worklight
OPERATION
Adjusting The Light Direction - See Figure 5
1.
Adjust the lamp heads by loosening the twist knobs on each side
of the lamp heads.
2.
Hold the top of the lamp heads and move forward or backward to
desired position. Retighten the twist knobs.
Turning The Lamp Head On- See Figure 6
NOTE: Always turn the lamp head off before you unplug the worklight
1.
Plug the power cord into a 120V outlet.
2.
Press the On/Off switch on the lamp to turn the lamp on (–) and
off (o).
CARE AND CLEANING / MAINTENANCE
CARE AND CLEANING:
CAUTION: Always make sure that the worklight is unplugged and
cooled down before attempting to clean it.
• Clean the lamp head, lens, cover, and lamp stand regularly with
a non-abrasive cleaner.
• Allow worklight to cool down completely before storing.
• Store in a safe place, out of the reach of children.
MAINTENANCE:
If the light does not work, check the following:
• Ensure the fixture is properly plugged into the power source.
• Ensure the switch is in the ON position.
FCC NOTICE CLASS B
CAUTION: Changes or modifications not expressly approved could
void your authority to use this equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved could void your
authority to use this equipment.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-005 (B)/NMB-005 (B)
www.e-conolight.com
|
Document:
Created By:
FIGURE 5
Lamp Head
FIGURE 6
888.243.9445
|
FAX: 262.504.5409
Date
DCR#
Twist Knob
On/Off
Switch
Tabla de contenido
