General Instructions - T&S B-0665-BST Serie Instalación Y Las Instrucciones De Mantenimiento

General Instructions

Note: This is a general instructional example of units using -BST.
Nozzles should be installed on unit fi rst.
Nozzle Installation
1. Remove no.6 from both sides of no.1.
2. Apply Loctite #680 to threads of no.5 and no.12.
3. Insert no.12 into no.11. Thread no.5 into no.11,
then rotate no.11 into no.1 until tight with no.12
facing front of sink.
4. Replace no.6 into no.1 following
nozzle installation.
Faucet Installation
5. Shut off water supply and drain
lines. Drill (2) two 7/8" [2.2 cm] holes in wall
or backsplash of sink, 8" [20 cm] center to
center, where you are installing no.1.
6. Apply tefl on tape or pipe joint compound to
threads of water supply lines.
7. Remove no.2 from no.1 and attach no.2 to water supply lines fl ush against
wall. Tighten by hand. Trim supply lines if necessary.
8. Attach no.1 to no.2, adjusting center to center fi t by turning no.2 if needed.
Make sure no.3 remains in place. Tighten no.2 fi rmly with a wrench.
9. Turn on water supply and check for leaks.
Upper Nozzle Support Installation
10. Attach no.14 to no.12 by screwing no.14 into clevis on no.12.
11. Position no.17 against wall. Mark holes and secure no.17 to wall using
no.15.
Adjusting Built-in Stops:
Insert a screwdriver to adjust no.4 at the base of
no.1 on each side. Water should be turned on
for this procedure.
Close Stop
turn clockwise
ex. model B-0665-BST
:
:
:
Open Stop
turn counter-
clockwise
14
12
clevis
apply loctite
no.4 adjusting
screw
Botton view of faucet body
5
17
15
16
11
5
2
1
4
3
water
supply
and Built-in Stop
6
wall
line