Singing Machine STVG-512 Manual De Instruccion página 12

CD OR CD+G OPERATION
D
Warning - Tapping or dropping the microphone while it is on can permanently damage
your microphone. Resist the urge to swing the microphone around by the cord!
PREPARATION
!
This unit is designed to play CD's bearing the identification logo
conform to the CD standard, they may not play properly.
!
Fingerprints and dust should be carefully wiped off with a soft cloth. Wipe in a straight motion
from the center of the disc to the outside edge.
!
Never use chemicals, such as record cleaning sprays, antistatic sprays or fluids, benzene or
thinner to clean compact discs. These chemicals will permanently damage the plastic
surface of the disc.
!
Always place the compact disc on the disc tray with the label facing upward. Compact discs
can be played on only one side.
!
To remove a disc from its storage case, press down on the center of the case and lift the disc
out, holding it carefully by the edges.
!
Discs should be returned to their cases after use to protect them from dust and scratches.
!
To prevent warping the disc, do not expose it to direct sunlight, high humidity or high
temperatures for extended periods of time.
!
Do not apply paper or write anything on either side of the disc. The inks used in some felt-tips
pens may damage the surfaces of the disc.
PLAYING CD OR CD+G DISC
Reminders:
!
Adjust MASTER VOLUME control on your unit, TV or audio system to a comfortable level.
!
Adjust MIC/ECHO/BALANCE controls as needed to achieve the desired mix of music and
vocals through your TV or sound system.
!
Do not press the disc cover of the CD compartment while it's playing.
!
Never place anything except a compact disc on the disc tray. Foreign objects can damage
the unit.
!
Do not apply excessive force to disc cover.
!
Only place one disc on the disc tray at a time.
TURNING POWER ON/OFF
!
To turn on the karaoke center, press the ON/OFF button, the ON/OFF LED will light up.
!
To turn off the system, press the ON/OFF button again, the ON/OFF LED will turn off.
FUNCTION SELECT
Set the FUNCTION SELECT switch to CD+G.
LOADING A DISC
!
Lift up the CD door to open the CD/CDG compartment. Place a disc in the compartment with
the printing side facing upward and the shiny side facing down.
!
Gently close the CD door to the CD/CDG compartment. After a few seconds, the LED will
display the total number of tracks.
(Refer to the Trouble Shooting Guide on page E14 if a disc is loaded but the total tracks
do not appear.)
(If no disc is loaded, it will display "
E11
" " . If CD's do not
".)