Quick Start Guide; Mounting - Rhino Winch 13500lb Manual De Instrucciones

13500lb - 17500lb - 20000lb

Quick start guide

Mounting

CAUTION: To prevent serious injury due to accidental activation, complete the winch installation before
wiring.
WARNING: Always choose a mounting location that is sufficiently strong to withstand the winch pulling
capacity.
WARNING: Always spool the winch rope onto the drum in the direction specified in the documentation.
This winch should always be mounted in a horizontal orientation with the rope winding on / off the
bottom of the drum. This ensures that the automatic brake will function correctly and it helps prevent the
rope from bunching on one end of the drum. Bunching can damage the winch.
Included Mounting Components:
4 x M10 locknuts (1.5), 4 x M10 bolts (1.5 / 35 8.8), 2 x 7/16 bolts (1 / 14)
1. Install a mounting bracket if necessary
2. If using a mounting bracket, fasten the fairlead to the mounting
bracket using the 2 x 7/16 bolts (1 / 14). If you're not using a
mounting plate, attach the fairlead where required. It must be
directly in-line with the rope spool direction.
3. Set the 4 x M10 locknuts (1.5) into the winch feet.
4. Thread the end of the rope through the opening of the mounting
bracket and fairlead.
5. Set the winch the in mount, install the 4 x M10 bolts (1.5 / 35
8.8) and tighten them. Always confirm required bolt length to
ensure proper thread engagement.
6. Attach the hook to the winch rope loop and attach the hook strap
to the hook.
© Rhino Winch Co
English
3