Safety System; Before Use; Using The Appliance - TEFAL ZN655H66 Manual De Usuario

EN
DESCRIPTION
- Pusher
A
- Feed tube
B
- Cover
C
- Sieve
D
- Juice collector
E
- Pouring spout
F
- Pulp collector
G
- Safety clamp
H

SAFETY SYSTEM

This appliance is fitted with a safety mechanism. To start the juice machine the cover
must be properly secured by the safety clamp
juice machine. At the end of a cycle, place the control switch
sieve stops completely before removing the cover.
(D)

BEFORE USE

We recommend that you wash all the
•
removable parts
them carefully.
Unpack the appliance and then place it on a flat, stable, heat-resistant work surface.
•
Ensure that all packaging has been removed before starting the appliance.
•

USING THE APPLIANCE

Fit the juice collector
•
Place the sieve
•
the drive shaft
Fit the cover
•
Click the safety clamp
•
Fit the pulp collector
•
Slide the pusher
•
small ridge in the feed tube.
If you wish to separate the juice from the froth, slide the foam separator
•
jug and fit the cover onto the juice jug (see Fig. 6). The foam separator allows you to
(N)
keep the froth into the juice jug when you pour the juice into a glass.
Position the juice jug
•
Fig. 7.
Plug in the appliance. You can use the cord storage
•
Fig. 8).
• When juicing hard foods we recommend a maximum quantity of 3Kg with a maximum opera-
ting time of 2 minutes. Some very hard foods may make your juicer slow down or stop. If
this happens switch off and unblock the filter.
(A, C, D, E, G, L, M, N)
on the drive shaft
(E)
in the juice collector
(D)
. You can hear an audible click (see Fig. 2).
(J)
on the appliance, ejection spout to the rear (see Fig. 3).
(C)
into place over the cover
(H)
on the rear of the appliance (see Fig. 5).
(G)
into the feed tube
(A)
under the pouring spout in front of the appliance as shown on
(N)
- Control switch (2 speeds)
I
- Drive shaft
J
- Motor unit
K
- Juice jug cover
L
- Foam separator
M
- Juice jug
N
- Brush
O
- Cord storage
P
. Opening the safety clamp
(H)
in warm soapy water (see cleaning §). Rinse and dry
(see Fig. 1).
(J)
. Ensure that the sieve is correctly clipped onto
(E)
(see Fig. 4).
(C)
, aligning the groove on the pusher with the
(B)
to adjust the length of the cord (see
(P)
4
will stop the
(H)
to 0 and wait until the
(I)
in the juice
(M)
(C)