Tabla de contenido
R
x 6
FIG. 6
6. Spread glue on the two sides of the notch and the top edge of one Back Leg (J). With the notch
snugly against the Left Side and Bottom Shelf, and the leg flush with the back edge of bottom
shelf, insert two #8x1
DO NOT INSERT SCREWS SO DEEP THAT THE SCREW HEAD GOES BELOW THE
SURFACE OF THE LEG!
Insert a #8x1
5
/
" Black Screw (R) down through the predrilled hole in the bottom shelf into the leg.
8
Repeat for the other Leg on the right side.
P
x 23
FIG. 7
7. With unit laying face down, to square the unit, measure diagonally as shown in FIGURE 7. Tap
the bottom of the side with the longer measurement until both the measurements are equal. When
it is perfectly square, center the Back (K) side to side and flush with the bottom shelf, with the cord
cutout toward the top, and good side in. Fasten in place with #6x5/8" Philtruss Screws (P) through
the predrilled holes.
J
R
R
J
5
/
" Black Screws (R) through the predrilled holes in the leg into the side.
8
P
FIG. 6A
K
P
P
P
R
J
FIG. 6B
P
Rev. 2/08 — 743Wa — Page 7
Tabla de contenido
