Installing The Wall Mount - Trust ZYCT-202 Manual Del Usuario

EN ZYCT-202 REMOTE CONTROL
COMPATIBILITY
The ZYCT-202 works with the Z1 ZigBee Bridge, ICS-2000 control
station and other Zigbee certified devices such as Philips Hue
(compatibility on trust.com/zigbee). With the ZYCT-202 it is not
possible to control the colors for the ZRGB-9 and the ZLED-9CW,
for this we advise to use the Z1 ZigBee Bridge or the ICS-2000.
1. BUTTONS
ON button to turn your lights/devices ON
OFF button to turn your lights/devices OFF
Dim up to increase the light brightness. Keep pressed for continuous
dimming
Dim down to decrease the light brightness. Keep pressed for
continuous dimming
Bulb selection. Press repeatedly to cycle through the bulb channels.
Press the smart group button to control all bulbs simultaneously
4
EN ZYCT-202 REMOTE CONTROL
2. REMOVE PULL STRIP
A
Remove the battery pull strip
by pulling it from the remote
control. Only after removing
the pull strip the remote can
be used.
3. CONNECT REMOTE WITH
BULB
A First select the bulb channel
you want to control the
bulb with.
B
Hold the remote as close
as possible to the bulb
and press and hold the ON
button to connect it.
C
Keep the ON button pressed
untill the bulb turns on and
off 3x.Keep holding the ON
button untill the bulb will
flash 2x to acknowledge that
the connection succeeded.
Note: To connect the remote
with the Z1 bridge or ICS-
2000 follow the steps in the
online (advanced) manual of
the Z1 ZigBee bridge or ICS-
2000. (trust.com/zigbee)
4. INSTALLING THE WALL
MOUNT
Remove the backplate of the
wall mount by lifting it up with
a flat screwdriver.
A
Place the backplate on a flat
surface and secure it tightly
with screws or use double
sided tape.
B
Attach the wall mount on
the backplate.
C
Place the remote on the wall
mount.
5