Idiomas disponibles
Idiomas disponibles
SEM10 (fig. 28)
SEM10 product has been designed to be installed under the kitchen cabinet, corresponding to
the downdraft lower air outlet . This product can work only if it is used in combination with a
downdraft equipped with external motor, manufactured by the same producer.
The appliance has been designed to suck vapours and odours in an optimal and almost noi-
seless way . We recommend to use the product only in FILTERING MODE and to use a constant
diameter piping of 150mm or similar sections.
We recommend to use piping without elbows, as they negatively affect the performance of the
appliance.
Installation procedure: place the appliance under the downdraft , corresponding to the air out-
let, as shown in (fig. 29).
All fittings are supplied with the appliance, along with a rectangular pipe that connects the
downdraft to the SEM10 product
The appliance air outlet shall be connected to the cabinet, in such a way that the air sucked in
the kitchen can be recirculated back into the room. Piping to be connected to the SEM10 pro-
duct air outlet are not supplied with the appliance.
It is possible to direct the product air outlet according to your installation requirements, by
rotating the air outlet flange as shown in (fig. 30).
The appliance is equipped with a 1,5 meter long power cable, to be connected to the hood in
the specific terminal board found inside the plastic black box (Fig. 8).
The product is supplied with a metallic joint (fig.31) which allows to put ahead the SEM 10, as
shown in fig 32. This possibility depends strictly on the dimension of the furniture.
When the joint in fig. 31 is used, it is very important not to use the white metallic flange, but
remove it as shown in fig. 30
With reference to the Energy Label standard and taking into account its performances, it is not
necessary to equip the product with any time control device.
19
