Setup Instructions - Belkin T9184ZM Guia Del Usuario

P74455ea_F8E477ea_man_rev.qxd
EN

Setup Instructions

1. Turn the iPod on.
2. Connect the Digital Camera Link (the Unit) to the iPod.
The Unit will turn on automatically. After a few seconds, the LED will turn
green to indicate proper connection. See below LED chart for further LED
interpretation.
3. Connect your digital camera to the Unit.
4. Press the button once on the Unit to initiate file archive.
5. After transfer is complete* (see LED chart below), the user has three options:
a) Press the button again to begin the data verification process; or
b) Disconnect the Unit from the iPod; or
c) Manually check the iPod for complete file transfer. Once the "OK to
disconnect" or the "Main Menu" screen appears after transfer is
complete, select "Extras > Photo Import" and select the roll
number for verification. Photos are listed on the iPod by roll
number in the "Photo Import" folder.
6. The Unit will power off immediately after disconnecting the Unit from the
iPod.
*You CANNOT view the photos on the iPod.
NOTE: Disconnect the Unit when not in use to preserve battery life. Belkin
recommends use of high-quality alkaline batteries. Battery life depends greatly on
the type of media being used and the type of battery being used; however, a single
set of high-quality alkaline batteries should allow transfer of 24 or more typical
128MB CompactFlash® cards (3GB or more of data).
NOTE: Do not disconnect the Unit from the iPod while files are being transferred.
The message "Do Not Disconnect" will appear on your iPod during the archive and
data verification process. It is safe to disconnect your Unit from the iPod when the
message "OK to Disconnect" or "Main Menu" is displayed on your iPod or after the
media transfer is complete.
12/7/04
2
11:57 AM Page 2
User
LED c
NOTE:
camer
state. T
NOTE:
strong
Should
Transf
Conne
comp
will op