Bostitch BTE360 Manual De Instrucciones página 6

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

BlAde INSTAllATIoN ANd ReMovAl (fIGuRe 3)
WARNING:
before making any adjustments or removing or installing attachments or accessories.
The blade should extend past the shoe and the thickness of the workpiece during the
cut. Select the blade best suitable for the material to be cut and use the shortest blade
suitable for the thickness of the material. Do not use jigsaw blades with this tool.
WARNING:
may occur if the blade does not extend past the shoe
and the workpiece during the cut. Increased risk of
personal injury, as well as damage to the shoe and
workpiece may result.
To INSTAll BlAde INTo SAW
1. Point tool away from body.
2. Rotate blade clamp collar in the direction shown in
figure 3.
3. Insert blade shank fully into blade clamp collar.
4. Release blade clamp collar to lock blade into position.
NoTe: Blade can be installed with the teeth up to
assist in flush-to cutting.
To ReMove BlAde fRoM SAW
WARNING:
before making any adjustments or removing or installing attachments or accessories.
WARNING:
with the blade may result in personal injury.
1. Rotate blade clamp collar to release position.
2. Remove blade.
To ReMove A BRokeN BlAde
If the blade breaks so that the broken piece is caught
inside the clamp, take the following steps to remove the
remainder of the blade from the saw.
1. Rotate blade clamp collar clockwise as viewed from the
back of the saw and hold in place (figure 4).
2. Turn the saw on its left side as viewed
from the back of the saw (figure 5).
3a. If the blade has broken inside the
clamp, slide a flat object into the opening of
the clamp (figure 6) as far as it can go, then
remove the flat object. This will disengage the
pin inside the clamp.
3b. If the blade has broken outside the
clamp, slide a flat object into the opening of the clamp
(figure 6) to the left of the blade as far as it can go, then
remove the flat object. This will disengage the pin inside
the clamp.
4. While still holding the clamp collar open and the saw
on its side, face the clamp opening down and shake until
the broken blade falls out.
oRBITAl AcTIoN SelecToR (fIGuRe 7)
BTE360 has dual blade motion: straight reciprocating
motion or orbital motion.
Straight reciprocating motion is used for all metal
cutting operations and for wood cutting applications
where finish is more important than speed. To set the
saw for straight reciprocating motion, turn the selector
to the position marked
orbital motion is used for fast cutting of wood. To set the saw for orbital action, turn the
selector to the position marked
cuT HAzARd. Turn off and disconnect tool from power source
cuT HAzARd. Blade breakage
cuT HAzARd. Turn off and disconnect tool from power source
Burn hazard. Do not touch the blade immediately after use. Contact
3
4
5
6
7
6
Tabla de contenido
loading

Este manual también es adecuado para:

Bte360k

Tabla de contenido