Comfort Glow ES4840 Instrucciones De Instalación Y El Manual De Propietario página 8

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

GLASS INFORMATION
1. Under no circumstances should this product be operated with missing or broken glass.
2. Do not strike or slam the glass.
3. Do not use abrasive cleaners to clean the glass.
Replacement glass is available from the manufacturer and replacement should be carried out
4.
by a qualified service person.
To clean the unit, first turn off controls on unit and unplug unit from power source.
To clean the glass door: remove dust with clean dry cloth or to remove finger prints and other marks
clean glass with clean damp cloth. Do not use abrasive cleaners or spray liquids on glass door surfaces.
Metal and metal painted parts should be cleaned with clean damp cloth only. Do not use abrasive
cleaners or spray liquids on this surface.
AUTOMATIC CUT-OFF
A cut-off switch is fitted to the heating element to prevent damage due to overheating. If it cuts-off due to an
obstruction in the airflow, the heater must be allowed to cool for 15 minutes and the obstruction must be
removed before restarting.
If the heater will not operate, please check the following before seeking repair of service:
1. Check if the power cord is plugged into an electrical outlet, if not, plug in.
2. Check if electricity to the outlet is working.
3. Insure the main power switch on the lower front of the heater is switched to "on".
4. If the power button on the front of the heater is turned on but the heater is not operating, then the safety
overheat function may have been triggered. Try pressing the power button. If the heater does not turn on,
clear any obstructions from front and rear of heater that may have caused internal overheating. Allow the
heater to cool approximately 15 minutes and then press the power button again
Note: The heater may not be operating if the thermostat is set lower than the room temperature. To begin
operation, increase the thermostat temperature for a higher heat setting.
WARNING: Wait until the unit has
completely cooled before attempting
any cleaning.
CLEANING
TROUBLE SHOOTING
~ 8 ~
Tabla de contenido
loading

Tabla de contenido