ASROCK P55DE Pro Manual De Instrucciones página 21

2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2 No. 22)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Serial ATAII Connectors
(SATAII_1: see p.2, No. 12)
(SATAII_2: see p.2, No. 13)
(SATAII_3: see p.2, No. 11)
(SATAII_4: see p.2, No. 14)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB12_13)
(see p.2 No. 17)
(9-pin USB10_11)
(see p.2 No. 16)
(9-pin USB8_9)
(see p.2 No. 19)
ASRock P55DE Pro / P55DE3 Motherboard
These four Serial ATAII (SATAII)
connectors support SATA data
SATAII_3 SATAII_1
cables for internal storage
devices. The current SATAII
interface allows up to 3.0 Gb/s
SATAII_4 SATAII_2
data transfer rate.
Either end of the SATA data cable
can be connected to the SATA /
SATAII hard disk or the SATAII
connector on this motherboard.
Besides six default USB 2.0
ports on the I/O panel, there are
three USB 2.0 headers on this
motherboard. Each USB 2.0
header can support two USB
2.0 ports.
the red-striped side to Pin1
2 1 2 1 2 1
2 1 2 1