Grounding Instructions - Chamberlain GPS1000 Manual Del Usuario

9. Reattach the ground wires onto the task light covers.
10. Reinstall the task light covers, insert the bottom tabs, press into place, and secure with the screws.
11. Plug the Garage Power Station into the electrical outlet. NOTE: The excess power cord may be wrapped
around the back of the mounting plate.

GROUNDING INSTRUCTIONS

This product must be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric current. This product is equipped with a cord
having a grounding wire with an appropriate grounding plug. The plug must be plugged into an outlet that
is properly installed and grounded in accordance with all local codes and ordinances.
WARNING: Improper installation of the grounding plug is able to result in a risk of electric shock. When
repair or replacement of the cord or plug is required, do not connect the grounding wire to either flat blade
terminal. The wire with insulation having an outer surface that is green with or without yellow stripes is the
grounding wire. Substitution of the signal word "DANGER" for "WARNING" is not prohibited when the risk
associated with the product is such that a situation exists which if not avoided will result in death or
serious injury. Check with a qualified electrician or serviceman when the grounding instructions are not
completely understood, or when in doubt as to whether the product is properly grounded. Do not modify
the plug provided; if it does not fit the outlet, have the proper outlet installed by a qualified electrician.
This product is for use on a nominal 120-V circuit and has a grounding plug similar to the plug illustrated
in sketch A in figure below. Only connect the product to an outlet having the same configuration as the
plug. Do not use an adapter with this product.
Use only a 3-wire extension cord that has a 3-blade grounding
plug, and a 3-slot receptacle that accepts the plug on the product.
Make sure your extension cord is not damaged. When using an
extension cord, be sure to use one heavy enough to carry the
current your product draws. For lengths less than 25 ft, 16 AWG
extension cords shall be used. An undersized cord results in a
drop in line voltage and loss of power and overheating.
Ground Wire
Grounding Pin
4
Light Socket
Light Bulb
Retainer
Ring
Task Light
Cover
Grounded Outlet
(A)
Grounded Outlet Box