Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4
LEARNING
4.1 Learning transmitter through the learning push button of the control card
MINI WIRELESS control card can be managed by all remotes WIRELESS series.
a
c
b
4.2 Learning subsequent transmitters with a transmitter already learned
⚠
Do not use this procedure if you have multiple units in operation, since the store opening would affect all devices where the channel is stored. In this
case, disconnect the power supply of the control boards which shall not be involved.
1. Opening of memory: Simultaneously press for 5 s the "a" and "b" keys of an already registered remote control. Once you open the
control board memory, it indicates this by turning on the red LED.
2. Press "a" button of the transmitter. The control card automatically memorize the "b" and "c" key too ("a" as "open" button, "b" as
"close" button and "c" as "stop" button). The control card signals the memorization of the channel with 2 flashings if the channel
was not memorized. With 1 flash if the channel was already learned.
3. Once memorized the channel, the control card goes back to normal operation. If no signal is transmitted by 20 s, the control board
exits automatically from the learning mode.
⚠
Buttons functions are only valid with DIP 4 OFF (see 6.2.4)
4.3 Parameter reset to factory defaults
This deletes all parameters (position automatic opening, alarms) without erasing all transmitters.
To restore the parameters to the factory default is sufficient to do the following:
1. Close the awning.
2. Press and hold for almost 7 seconds the learning key until the red LED alarm / learning flashes rapidly.
3. Release the button.
The red LED stops blinking. The restoration has been performed.
4.4 Resetting the memory and reset to factory settings
At any time it's possible to reset the factory settings by resetting the card. This also leads to the cancellation of all the remote
controls, sensors and automatic opening position. To reset the board is sufficient to do the following:
1. Remove power to the control board
2. Press and hold the learning key while the control board is powered up. The three LEDs red, green and yellow flash once and after
that they stay on.
3. Hold down the learning key until the red LED turns off.
4. Release the learning key.
After this operation every remote control and wireless sensor must be programmed again.
1. Press and release the learning key on the MINI WIRELESS; the red LED lights up.
2. Press "a" button of the transmitter. MINI WIRELESS automatically memorize the "b" and "c" buttons
too ("a" as "open" button, "b" as "close" button and "c" as "stop" button). MINI WIRELESS signals
the memorization of the channel with 2 flashings if the channel was not memorized, with 1 flashing
if the channel was already learned.
3. Once learned the channel, MINI WIRELESS goes back to normal operation.
If no signal is transmitted by 20 s, MINI WIRELESS automatically exits from the learning mode.
⚠
Buttons functions are valid only with DIP 4 OFF (see 6.2.4)
14
Tabla de contenido
