Replacing The Cutting Head - Olympia Vario duplex 4000 Manual Del Usuario

Replacing the Cutting Head

When the blade of the cutting head is damaged or worn, the cutting head
must be replaced.
1 Remove the end cap of the guide rail from the base plate (Fig. 8, A)
by pulling it upwards.
2 Pull the guide rail out of the base plate (Fig. 8, B).
3 Remove the cutting head from the guide rail (Fig. 8, C).
4 Replace the old cutting head with a new one.
5 Slide the guide rail back in the base plate and install the new cutting
head in the process.
6 Insert the end cap from above on the opening at the end of the guide
rail.
Note: Only the entire cutting head can be replaced. To obtain a new
cutting head, please telephone our hotline.
Fig. 8
20