Light Bulbs - Broan Best IS23 Manual De Instrucciones

OPERATION
Controls
The hood is operated using the (4) push-
buttons located at eye-level, on the front edge
of the hood.
The light switch turns the lights on and off.
The blower on-low / off switch turns the
blower on to its lowest running speed. The
blower must be turned on using this switch.
Turn the blower off by pressing this switch a
second time.
The blower medium speed switch changes the blower speed to medium. This
switch works only if the blower is already running at low or high speed.
The blower high speed switch changes the blower speed to high. This switch
works only if the blower is already running at low or medium speed.
The pilot lamp lights up whenever the blower is on.
HEAT SENTRY™
Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a
device that will turn on or speed up the blower if it senses excessive heat above
the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting - it turns blower up to HIGH speed.
When the temperature level drops to normal, the blower will return to its original
setting.
WARNING
The HEAT SENTRY thermostat can start the blower even if the hood is turned
OFF. When this occurs, it is impossible to turn the blower OFF with its switch.
If you must stop the blower, do it from the main electrical panel.

LIGHT BULBS

This hood requires two 9-Watt fluorescent light
bulbs.
ALWAYS SWITCH OFF THE ELECTRICITY
SUPPLY BEFORE CARRYING OUT ANY
OPERATIONS ON THE APPLIANCE.
To change bulbs:
1. Remove the light lens cover.
2. Remove the bulb by pulling sideward (Do not rotate). CAUTION: BULB MAY
BE HOT!
3. Replace with a bulb of the same type.
LIGHT
SWITCH
BLOWER
ON-LOW /
OFF
SWITCH
REMOVE LIGHT LENS COVER
- 4 -
BLOWER
MEDIUM
SPEED
BLOWER
HIGH
PILOT
SPEED
LAMP