Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Maintenance & Troubleshooting
WARNING!
The strobe power supply is a high voltage device. To
avoid the risk of electrical shock, wait 5 minutes after
turning off power before removing lens for access to
internal parts of the strobe heads.
Most strobe failures can be traced to wiring or battery prob-
lems. Check all wiring and connections to insure the correct
voltage is reaching the strobe light. If the strobe operates
erratically or stops completely, and the wiring is not at fault,
the flashtube is probably worn. To replace it, remove the
outer dome. Unscrew and remove the inner lens. Remove
the flashtube by squeezing on the tabs on the side of the
tube holder and pulling up. Plug in the new tube assembly.
See Figure 4.
Replacement Parts/Accessories
Description
Replacement Dome Lens, Amber
Replacement Dome Lens, Blue
Replacement Dome Lens, Clear
Replacement Dome Lens, Green
Replacement Dome Lens, Red
Replacement 3.5" Lens, Amber
Replacement 3.5" Lens, Blue
Replacement 3.5" Lens, Clear
Replacement 3.5" Lens, Red
Flash Tube
Note:
Operating the vehicle without the lens installed on the product, may result in damage that will NOT be
covered under warranty
920-0014-00 Rev. C
Note: The connector is keyed to ensure proper orienta-
tion. Make sure that the three contacts on the bottom of the
flashtube are straight. Do
not force. If trouble continues, return product to your local
dealer for warranty replacement, or call ECCO Customer
Service for assistance (800) 635-5900.
Part No.
R5101LA
R5101LB
R5101LC
R5101LG
R5101LR
R5150LA
R5150LB
R5150LC
R5150LR
R6501FT
Page 4 of 5
Tabla de contenido
