Idiomas disponibles
Idiomas disponibles
EN
Important announcement
Please read this user's manual carefully before installation to get the water cooler's best performance
by optimized installation. Nox Xtreme is not responsible for any damage to the product or injury caused
by incorrect installation or user's carelessness. The water cooler may cause interference with some
motherboards. If you face an interference between Hummer cooler and your motherboard, please stop
installing it. Be careful not to hurt yourself by the radiator while installating & disassembling the water
cooler. Do not move the water cooler around after the installation to prevent CPU damage. Please, do not
use the water cooler for any other usage apart from the original purpose.
Warranty
For your warranty claims, please contact Nox Xtreme overseas distribution partners in your country.
Find the distribution partner list at www.nox-xtreme.com
Warranty: 2 years from purchasing date. (Depending on the laws of each country)
URL: www.nox-xtreme.com
E-mail: [email protected]
Components description
1
2
3
6
7
8
Install the right brackets
According to your socket, choose the right mounting bracket and mout them by the screws.
4
5
1) Cooler x1
2) AMD clip x1
3) Intel LGA 2011/2066 clip x2
4) Intel LGA 115X clip x2
5) Fan clip x2
6) Screw x4
9
7) Intel LGA 115X backplate x1
8) Thermal grease x1
9) ARGB internal controller x1
Intel installation
LGA1150/LGA1151/1155/1156 - LGA2066/2011
1) Stick the LGA115X backplate to the back of
2) Apply a thin layer of thermal grease to the
the motherboard.
CPU surface.
AMD installation
1) Remove original AMD plastic retention
2) Apply a thin layer of thermal grease to the
frame, but keep the backplate.
CPU surface.
CPU fan header
Connect CPU small 4pin power cable to "CPU_FAN"
header on the motherboard.
Use motherboard RGB control
Motherboard ARGB control
A) If your motherboard has any
ARGB lighting system, plug the ARGB
Hub adapter into the motherboard
and make sure the pin with an arrow
is connected to the 12 V pin on
motherboard.
(For LGA2066/2011: follow steps 2 and 3)
3) Put the heatsink onto the CPU, tightening
the bracket screws into the backplate to
secure the heatsink firmly.
3) Put the heatsink onto the CPU, tightening
the bracket screws into the backplate to
secure the heatsink firmly.
Internal RGB controller features:
MODE:
Press this button to switch the lighting into a dynamic mode.
COLOR:
Press this button to switch the lighting into a static mode. There a lot
of different colors for choice.
SPEED:
Change the speed of the color changing.
Internal ARGB controller
B) If your motherboard doesnt has
any ARGB lighting system, plug the
ARGB hub adapter into the internal
ARGB controller in the way showed
in the picture above. Then connect
the Internal RGB controller to a PSU
connector.
