Intex CS3220 Manual Del Propietário página 19

Ocultar thumbs Ver también para CS3220:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 43
TROUBLESHOOTING GUIDE (continued)
LED PANEL
CODE
LED Panel Code Flash & Alarm On (NOTE: Always turn off the power before cleaning and servicing).
1. Filter pump not attached to
system and/or switch on.
2. Circulation line is blocked.
3. Incorrect inlet and outlet hose
direction.
4. Scale on flow sensor pins inside the
titanium electrode.
5. Electrode cord is loose.
6. Inner timer conflict between filter pump
and saltwater system.
1. Dirt or scale on titanium plates.
2. Low salt level / No salt.
3. Electrolytic cell cord is loose.
4. Possible electrolytic cell failure.
1. High salt level.
2. water temperature > 35ºC.
3. Titanium electrode failure.
If you continue to experience difficulty, please contact our Consumer Service Department for
assistance. See separate "Authorized Service Centers" sheet.
SAVE THESE INSTRUCTIONS
(133IO) SaltwatEr SyStEm ENGlISH 7.5" X 10.3" PaNtONE 295U 07/21/2020
PROBLEM
IMPORTANT
SOLUTION
• Ensure a filter pump with the correct flow
rate is attached and operating. See "Setup
Instruction".
• Remove the black hat-like plugs from the
pool strainer connectors.
• Clear your filter cartridge and cell from debris
and dirt. See "Maintenance".
• Release all trapped air in the circulation line.
See the filter pump manual.
• Check the direction of the inlet and the outlet
hose. Reverse the hoses if necessary. See
"Set Up Instructions".
• Clean the titanium electrode. See
"Maintenance" section.
• Plug the cord into the electrode and tighten
the plug collar firmly.
• Reset both timers on the filter pump
and saltwater system.See "Operating
Instructions".
• Remove primary electrolytic cell for
inspection. Clean it if necessary. See
"Maintenance".
• Add salt. See "Salt & Pool water Volumes".
• Ensure that the cell cord is plugged firmly
into the cell housing receptacle.
• Contact Intex Service Center. Replace the
cell if needed.
• Partially drain the pool and refill it with fresh
water. See "Salt & Pool water Volumes".
• Contact Intex Service Center.
• Contact Intex Service Center.
133
English
A
Page 19
Tabla de contenido
loading

Tabla de contenido