Tabla de contenido
kiTe: 4-line closed cell
To 5-line oPen cell
imPortant:
5-line open cell mode is
recommended for Snow and land use only.
the air intake valves MuSt be open when
using 5-line mode – if the valves are not set
open this will compromise the functionality of
the internal re-ride release System and could
cause to damage to the kite.
each line is stored inside the kite in a pocket on the rib (profile section) with the line end attached to an internal knot.
Feed the isl line through the plastic ring on the bridle line tab next to the zip. Feed the line from the wing tip side towards the center.
14
lay out the kite and speed systems as you would for set up.
5
1
Unwind the lsl line. Ensure there are no tangles or
knots in the line.
disconnect the isl line from the internal knot and pull the line out of the pocket.
Ensure there are no tangles or knots in the line.
2
Open the undersurface zips (next to the centre of the
kite) to access the ISL lines (left and right) ..
4
Close the zip until 5mm before the slider goes into the bungee
cover, leaving room for the isl line to run freely.
3
6
Tabla de contenido
