Operation - Olympia TB-1250 Manual Del Usario

Operation

Assemble the metal bracket enclosed for cooling the bound folders.
Connect the power cable to an easily accessible, standard electrical socket.
Caution: Check that the voltage specifications of the unit correspond
to that of your power supply network (230 V, 50 Hz).
1 Switch on the On/Off switch on the right-hand side of the unit
(Position "I").
2 Wait until the yellow indicator lamp (Ready) lights up and an acoustic
signal is issued. The warm-up phase requires approx. 3 minutes.
3 Use the folder width switch to set the required width. (on the left-hand
side of the unit).
Binding time for < 16 mm = 80 seconds // >16 mm = 120 seconds
4 Insert the paper in the corresponding folder.
5 Insert the folder in the binding slot with the closed side at the bottom.
The integrated clamping mechanism holds the paper perpendicular.
6 Press the BINDING button; the green LED flashes.
7 When binding has been completed successfully, an acoustic signal is
issued and the green LED stops flashing.
8 Remove the folder and place it in the cooling device for 10 minutes.
Too short a cooling phase will result in sheets being loose.
9 Repeat steps 3-8 to bind more folders.
Caution: The spine of the folder just bound is very hot.
Overheating Protection with Auto Off Feature
1 The unit is equipped with an Auto Off feature to protect folders, which
have not been removed, from overheating.
2 When the binding process is finished, an acoustic signal is issued
and, at the same time, the Auto Off feature is activated.
3 If the BINDING button is not pressed again within approx.10 minutes,
the power supply is electronically switched off to prevent overheating.
4 To start binding again, the unit must be switched off and on again.
9