Selecting The Temperature; Steam Ironing; Shot Of Steam - Aigostar 8433325500931 Manual De Instrucciones

Suggestions before using the iron for the first time
1. Certain parts of the iron have been lightly greased therefore the iron could
give off a little smoke when plugged in for the first time. This will cease after a
short while.
2.Before using the iron for the first time , remove the plastic protector from the
base (if it has one) clean the base with a soft cloth.
3. Keep the base very smooth. Do not run it over metal objects (such as against
the ironing board, buttons , zips ,etc.)
4. Pure wool fibres (100% wool)can be ironed with the appliance in the steam
position .by preference ,select a high steam position and use a dry ironing cloth.

Selecting the temperature

1.Check the ironing instructions on the garment to be ironed.
2.If the garment does not have any ironing instructions but you know the kind of
fabric in question, use the chart below.
3. Fabrics that have some kind of finish(polishing . wrinkles , contrasts....)can
be ironed at the lowest temperatures.
4.If the fabric contains several kinds of fibres ,always select the temperature
applicable ,if an article contains 60% polyester and 40% cotton ,you must always
choose the temperature corresponding to polyester and without steam.
5. First classify the articles to be ironed according to the most suitable ironing
temperature : wool with wool, cotton with cotton, etc. as the iron heats up as fast
as it cools , start by ironing the articles requiring the lowest temperature such as
those made of synthetic fibres . Progress towards those that require the highest
temperatures.
6.Turn the temperature control until it is in front of the appropriate signal
according to the following:
·
position for nylon and acetate
· ·
position for wool ,silk or mixures
· · ·
position for cotton or linen (steam).
How to fill the water tank.
1.Unplug the iron.
1. Set the steam ruler to dry ironing .
2. Fill the tank through the filling hole.
3. If you have hard water ,it is advisable to use only distilled or demineralized
water.
-do not use chemically de-limed water or perfumed
4.Do not store the iron with water in the tank.

Steam ironing

1.Fill the iron as described in the section "how to fill the water tank".
2. Plug the iron into the mains.
3.Steam ironing is only possible when the highest temperatures shown on the
temperature control are selected .
Otherwise ,water may escape through the soleplate.
4. Wait until the pilot light goes out , which indicates that the selected
temperature has been reached.
5.Turn the steam button to the required position.
6.When the ironing is finished and during breaks in ironing , place the iron in its
upright position.
7.Disconnect the iron from the mains supply . Pour of any remaining water and
leave the iron to cool off.
Spray
1.The spray can be used in any position, either in dry or steam ironing, as long as
the water tank is filled with water.
2.Press the spray button for this function
NOTE : This button has to be pressed repetitively to start this function for the
first time.

Shot of steam

Shot of steam give extra steam for removing persistent wrinkles.
1.Place the temperature selector at the "max"position and wait until the pilot
light goes out
2.Wait for a few seconds for the steam to penetrate the fibre before pressing
again.
NOTE : For the best steam quality, do not use more than three successive
3