Preparing The Water Connection; Drain Preparation; Installation Preparation - AGA marvel AELTTDW Guia De Instalacion

Ocultar thumbs Ver también para AELTTDW:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Preparing the Water Connection (A)
• Install an easily accessible shut-off valve (not
supplied) in the water supply line. All solder
connections must be made before the water line
is connected to the dishwasher's water inlet valve.
Water can also be supplied to the dishwasher by
using a flexible braided hose line.
• Check with your plumbing supply sources for the
proper hose and 90° elbow and necessary fittings
for the water supply line. This material is not
supplied and must be purchased separately.
Installing the 900 elbow Fitting (B)

Drain Preparation

Under the Sink Drain
• Install a Y-branch tail pipe
(Figure A).
A
Installing an Air Gap
• If the local ordinance requires
an air gap (Figure B).
B
Disposal
• Remove the drain connection
plug before attaching the drain
hose from the dishwasher.
• Every disposal has a hook-up
for a dishwasher; consult your
disposer manual for correct
connection (Figure C).
C

INSTALLATION PREPARATION

Do not overtighten the 90° elbow. Doing so may damage the
water inlet valve and cause a water leak.
If the water supply line is to be copper tubing, make certain that
the elbow has a compression fitting. Apply Teflon tape or other
pipe sealant when required. Orient the water supply connection
downwards as shown in the figure so the water line can be easily
pulled underneath or on the side of the dishwasher.
WARNING
Installation should be performed by a qualified
installer. Work by unqualified persons could be
dangerous and may void the warranty.
If the dishwasher is installed in a location that
DANGER
experiences freezing temperatures (e.g. in a
vacation home, cabin, etc.), you must drain
all the water from the dishwasher's interior.
Water system ruptures that occur as a result of
freezing are not covered by warranty.
CAUTION
NOTICE
• Either one of the above methods must be used or
the dishwasher will not operate properly.
• A hose that attaches to a sink spray can
FOR YOUR SAFETY
burst if it is installed on the same water line
as the dishwasher. If your sink has one, it is
recommended that the hose be disconnected and
FOR YOUR SAFETY
FOR YOUR SAFETY
the hole plugged.
• The total length of the drain hose is 76-3/4"
(1950mm). If a hose extension is required, a
drainage hose of equal quality must be used.
• The maximum length must not exceed 157-1/2"
(4000mm). Otherwise, the cleaning process is
negatively influenced.
You must add a loop at least 28" (71.1cm) above
the floor of the cabinet and above the drain
connection in the drain hose to prevent waste
water from not draining properly and causing either
poor washing results or a bad odor.
FOR YOUR SAFETY
Check with local ordinance for type of air gap
required.
10
FOR YOUR SAFETY
WARNING
WARNING
DANGER
DANGER
WARNING
CAUTION
CAUTION
WARNING
DANGER
NOTICE
NOTICE
DANGER
CAUTION
NOTICE
CAUTION
NOTICE
Tabla de contenido
loading

Este manual también es adecuado para:

AlttdwAmcttdwAmprottdwHcttdw

Tabla de contenido