Shs-5300 Heating Controller Installation And User Manual; Composition Of The Product; Initial Use - Smartwares SHS-53000 Manual De Instrucciones

SHS-53000 heating controller
EN
installation and user manual
1. Introduction
1.1. Description of the product
Intended and unintended use
The SHS-53000 heating controller is a programmable
heating controller. The heating controller is intended
for controlling a single radiator. Any other use than
the intended use described above is considered as
unintended use. Smartwares shall not be held liable for
any damage caused by unintended, incorrect or unwise
use.
1.2. Environmental influences
Use the heating controllers only indoors and do not
install it in a magnetic field. This can cause damage to the
internal components.
1.3. Used symbols
Warning! The user may cause (severe) injury to
!
himself or seriously damage the product. A warning
indicates the possibility of injury to the user or
damage to the product, if the user does not perform
the procedures carefully.
Please note! A note with additional information
!
for the user. A note is intended to alert the user of
possible problems.
Tip! A tip makes the user aware of convenient
functions and additional options.
2. Precautions and safety instructions
Warning!
!
• Do not install the product outdoors, or in places
where it may get wet.
• It is not permitted to open the product yourself or
to have it opened, neither is it permitted to repair
the product yourself or to have it repaired. In that
case warranties will expire.
• Only use original accessories from the
manufacturer.
• Keep the product out of reach of children.
• Use a dry, clean cloth to clean the product.
• Do not use abrasives, corrosive detergents, agents
containing bleach or solvents to clean the product.
Please note!
!
• Install the product as indicated in this manual. In
case of doubt, consult an authorized mechanic and
always observe the local installation regulations.
• When resetting to factory settings, all settings will
be replaced. This means that you will lose your
manually set programs and pre-sets. You cannot
retrieve these.
• The packaging materials may not be disposed of as
unsorted municipal waste, but must be collected
separately.
6
3.

Composition of the product

3.1. Main components
1
1. Fixing ring
2. LCD display
3. Menu button
Press this button to switch between automatic
settings (AUTO), manual settings (Manu) or the
holiday mode.
4. OK button
5. button.
This button switches between the 2 settings, high
and low .
6. Valve control
7. Battery compartment
8. Rotary knob
9. Remote Control
a. LED
b. UP button
c. DOWN button
d. Battery compartment
3.2. Accessories
2
These accessories are applicable for mounting on a
Danfoss valve.
(All trademarks and registered trademarks are the
property of their respective owners.)
1. Danfoss RA ring
2. Danfoss RAV ring
3. Danfoss RAV cap
4. Danfoss RAVL ring
3.3. Overview display
3
1. RF indicator
2. Day
3. Time
4. Date
5. Holiday mode
6. Manual settings
7. Automatic settings
8. Low and high temperature indicator
9. The set temperature
10. Window open
11. Low battery indicator
12. Program indicator
13. Time indicator
4.

Initial use

4.1. Inserting the batteries
The heating controller
4
1. Slide the battery cover from the product.
2. Insert 2 AA batteries (not included).
Pay attention to the "+" and "-" polarity!
3. Replace the battery cover on the product.
Remote control
5
1. Open the battery compartment.
2. Insert the battery.
3. Close the battery compartment.